Unsafe Scuba Flex Hoses | Check Your Regulators Hoses! | Scuba Advice

7 35



Lately we get a lot of questions about unsafe regulator flex hoses. You might have seen some reports about hoses getting clogged and basically cutting of the air. In this article we will tell you how to check your hoses and to make sure you’r safe.

What is the problem?

Luckily scuba equipment failing or breaking down has become a rarity and we don’t see it that often anymore. So when something happens institutions like DAN are sure to look into the problem to determine what went wrong. One diver reported that despite his tank being full he experienced an out of air situation. After research the regulator seems to be fine and the attention shifted towards the hoses. When cut open large yellow crystals emerged which clogged the entire hose and essentially blocking the inlet of the second stage.

The outside of the hose looked pristine which made the case even more curious. After more research it became clear that through the heating and cooling of the hose, the inner layer transform into a wax like substances through the chemical proces called hydrolysis. The hose heats up on the surface when it’s placed in the sun and cools when the cooler breathing air is passing through it.

Polyether vs Polyester

After the incident more dive operators and divers called in their problems with braided hoses and the problem seems to be more wide spread than first assumed. The issue only seems to be with braided flex hoses and with one sort in particular. Hoses with a inner layer of polyester are the only ones affected. Hoses with a Polyether lining seem unaffected and are safe to use. Most of the cases also seems to be located in tropical area’s where the hose heats up enough to start the proces of hydrolysis. You need to be in tropical area’s for an extended period for crystals to form.

Miflex hoses with a polyether lining (safe to use):

Report faulty hoses to DAN: [email protected]

Join the 50ft Below community on:
Facebook:
Instagram:
Twitter:
Website:
#scubahowto #scubadiving #scubaadvice

Rating: 4.94

7 Comments
  1. Tom S says

    Great video! Thank you. I am a new diver, I was hoping you might be willing to make a video about safety, including ascension rates and safety stops. Thanks again for your videos.

  2. Hellrazor says

    Are Mares flex hoses made with Polyether? which Brands have failed??

  3. Yudi Herdiana says

    Thanks a zillion!!!

  4. Rick Kinney says

    Very good to know. Much appreciated.

  5. Mike Smith says

    Thanks – useful information.

  6. Milton Stennett says

    Thank you very much for the information.

  7. Michael Thomson says

    Good report, thx 😉

Leave A Reply

Your email address will not be published.