Hollis Solo Harness System

1 25

The Hollis Solo Harness is assembled using a single piece of two inch webbing to eliminate failure points. This Hollis Harness system is designed to meet the needs of all technical divers, providing a clean, simple system that can be fully adjusted to suit the divers needs and specific size.

The Hollis Solo Harness is supplied with:

  • The harness webbing
  • Four pre-bent stainless steel D-rings
  • Three standard stainless steel D-rings
  • Two shoulder pads (not required if you don’t want them fitted)
  • Webbing sliders to securing D-rings
  • Rubber loops
  • Stainless steel belt buckle
  • Two inch webbing crotch strap with slider and D-ring

Please note that the backplate is not included and is shown for assembly purposes only.

Rating: 4.82

1 Comment
  1. David Polley says

    The bands are also meant to be installed on each arm strap for securing backup torches

Leave A Reply

Your email address will not be published.